(Quick Disclaimer..... While this craft does take longer than an hour and could cost you more than $25..... it is definitely worth it!!!  Designer shoes that are similar to these could cost you thousands of dollars. So a few evenings spent adding some bling is a life saver to the die hard fashionista :) Enjoy!)

   Aren't these shoes totally gorgeous?! I made these to wear to my brother in law's wedding. The look on ladies faces when they spotted my heels was unforgettable. Tongue on ground with drool. Even dudes we stopping me asking where I got these bad boys. Ha! The satisfaction you get when you make the statement 'Oh these? I made them'. Love it!
   While during this tutorial I am blinging out some heels you can easily apply crystals to ballet flats, headbands, bracelets, jeans and the rest of your wardrobe.
  This is what I do for a living, HERE at Sue's Sparklers. We sell all of the tools & materials (except for the heels) in this tutorial, so please stop by and give the site a look. You will not be disappointed!

How to use a Bejeweler (Heat Set Wand)



What you need: A Bejeweler with interchangeable tips. You can pick one up HERE
Some Hot Fix Crystals, I recommend 16ss Clear Swarovski Crystal. Swarovski is fabulous. You can pick some up HERE
I grabbed a package of 10 gross or 1440 pieces. You do use a lot of crystal on heels. Size 16ss or 4mm is the best size to start with. Not to big and not to small.
Then you need a pair of suede or fabric heels. It needs to be a porous material so the glue has something to hold on to. Slick leather is a no go.

Oh Swarovski... you are so pretty! See the gray back? That is the hot fix glue, which makes it work with the Bejeweler Heat Setter Tool. Sooooo much easier then applying glue to each crystal & much less mess.

Lay out all of your crystals sparkly side up. Work on a hard flat surface, a wood cutting board works great. Make sure the right tip is screwed into the Bejeweler, it is inscribed on the side of each tip. Plug your Bejeweler in and give it a few minutes to get nice and hot.

To pick up the crystal, very gently place the Bejeweler tip directly on top of the crystal. Do not push down hard. Hold it there for a few seconds, the heat causes the crystal to expand slightly, and the tip will hold the stone.

Pick up the crystal and look at it. This is key. You are watching the back side, the glue, melt. It should bubble slightly and glisten. For a size 16ss or 4mm crystal it takes about 5-8 seconds for it to melt completely.

Gently touch the tip to where you want the crystal. The hot glue will pull the crystal out of the Bejeweler tip and set itself on to the fabric. I will give it a little extra by pushing the crystal on to the fabric to make sure it has a very secure hold. Be very careful! It is hot! Band-aide maybe?
Tip: If the crystal gets stuck in the tip, have a push pin in hand. Slide it into the slot on the tip and gently pull the crystal out. See the slots on the tip in the picture above? Very convenient.

Wha-La!! That is how you use the Bejeweler. Just repeat, repeat and repeat until you have covered what you want or you run out of crystals :) Hope you get addicted to blinging, just like I have! Soon you will start thinking everything you own will look so much better with a little crystal here and there.


Gorge!

Bananas!

Oh darling please!


Thank you for stopping by!